The Kenwood KAC-M3001 Compact Mono Digital Amplifier is a class D amplifier with a conformal coating and variable low-pass filter.
Power a sub wherever you go
Kenwood’s KAC-M3001 compact mono subwoofer amplifier will power the bass in your vehicle with up to 300 watts RMS. That’s enough to hear the bass clearly above the noise of the road, trail, or waterway as you travel along. This little powerhouse will fit almost anywhere, including a storage compartment on a boat, motorcycle, or ATV, so you can put great bass in whatever vehicle you wish.
Weather-resistant protection for music on the go
Conformal coating protects the internal circuits from water and dirt, so the show will always go on, even through the roughest conditions. The subwoofer output terminal features a plastic-covered plug that provides further protection for the connection.
High-level inputs ease installation
The KAC-M3001 will accept a signal from just about any source, whether you’re using RCA cables from an aftermarket receiver or speaker wires from a factory radio. When you use the speaker-level inputs, the amplifier will sense the signal and turn itself on, so you won’t need to run a remote turn-on lead to your car stereo.
Multi-Application
Many of today’s powersports have very limited space to work in and tend to be a harsh environment for electronics because of the exposure to outdoor environments. KENWOOD’s compact performance marine are small in size so they fit even the most limited installation areas. The marine also use a conformal coated main PCB (printed circuit boards) which offer extra layers of protection to help prevent moisture or damp air from damaging the product.
Product: Kenwood KAC-M3001 Compact Mono Digital Amplifier
Dimensions
203.2 × 129.794 × 406.4 mm
Performance
RMS Power Output (Watts x Channels): 200 x 1
Peak Power Output (Watts x Channels): 600 x 1
Power at 2 Ohms (Watts x Channels): 300 x 1
Minimum Impedance Unbridged: 2
Minimum Impedance: 2
Best Frequency Response: 20-200 Hz
THD at Rated RMS Power: 1%
Signal to Noise Ratio: 97 dB
Input Voltage: 14.4v
Features
Amplifier Class: D
Low-Pass Crossover Frequency: 50-200 Hz
Low-Pass Slope (dB/octave): 24 dB/octave
Bass Boost: No
Fan Cooled: No
Fuse Rating: 30
Speaker Level Inputs: Yes
Preamp Outputs: No
Width (inches): 6-7/8
Height (inches): 1-13/16
Depth (inches): 3-7/8
What's in the box
Kenwood KAC-M3001 owner's manual
Mono block amplifier with a 30A ATM mini-fuse installed
9" Speaker output harness (4-pin Molex plug on one end)
4 Self-tapping screws (M4 x 16mm)
Two 13.5" plastic wire ties
Clear plastic self-adhesive Protective Covers for Controls (1 sheet)
Instruction Manual/Warranty Card
Mobile Amplifier Channels
1 Channel (Mono)
Mobile Amplifier Class
Class D
Mobile Amplifier Features
Low-Pass Filter, Speaker Level Inputs
Mobile Amplifier Fuse Rating
30
Mobile Amplifier RMS
201 to 350 watts
Mobile Min Impedance
2
Estimated Shipping
When you add an item to your cart the Estimated Shipping* cost will be shown. This estimated shipping* cost is accurate to most major city locations across Canada. If the shipping cost is higher than the estimated shipping* then GibbysESM will contact you for approval before we process your order.
Reviews
There are no reviews yet.