PAC SWI-RC Steering Wheel Control Car Stereos Adapter
PAC SWI-RC adapter allows you to use the steering wheel audio controls in a wide variety of vehicles to command select radios from Alpine, Clarion, Dual, Jensen, JVC, Kenwood, Pioneer, and Sony.
Installation is Straightforward
connect a few wires, then program the adapter for your particular car and your stereo, and you’ll retain the convenience of your steering wheel controls. The direct connection to the stereo eliminates the need for an infrared emitter, allowing the interface to function even in bright sunlight. Step-by-step LED confirmation makes programming easy. Once connected, the SWI-RC’s failsafe memory will learn up to 12 stereo functions, retaining them even if battery power is interrupted
On some vehicles, you may need a voltmeter to locate the correct wires to connect to the SWI-RC. If you have no car audio installation experience, you should consider professional installation. The SWI-RC works with most Alpine, Clarion, Dual, Jensen, JVC, Kenwood, Pioneer, and Sony stereos that have a wired remote control input port or a dedicated steering wheel input, but please call or email us to confirm compatibility with your radio.
You’ll usually have to tap into one to three wires in your vehicle at the radio location to connect this interface. If you’re using a PAC OEM integration adapter to connect your new car stereo to your vehicle, then it most likely will have a prewired connector for this PAC steering wheel audio control adapter. In these cases, no additional wiring in required.
Steering wheel control interface module (with attached 9″ blue/yellow wire and 34″ cable terminated by a right-angle male 3.5mm connector)
24″ Wiring harness
Packet of 8 resistors (includes 47 ohms/100 ohms/150 ohms/560 ohms/1000 ohms/1500 ohms/3900 ohms/5100 ohms)
2 Vehicle Connector Charts
Bluetooth Commands note