Rockford Fosgate RFK1D 1/0 AWG Dual Amp Wiring Kit

1/0 gauge complete power, ground and signal installation kit for two amplifiers.

RFK1D Features:

• FULL spec cable – meets or exceeds AWG (American Wire Gauge) requirements
• 1/0 AWG (53.5mm²) 4,704 strands
• 100% Pure Crystal-Oxygen Free Copper (PC-OFC)
• 4 AWG (21.1mm²) 1,862 strands
• Includes appropriate wire termination hardware
• 16 AWG (1.31mm²) 65 strands

CEA-2015

Rockford Fosgate cables conform to the CEA-2015 industry standard. The standard specifies the exact amount of copper needed to indicate a specific wire diameter or gauge size (8 AWG, 4 AWG, etc). Some manufacturers substitute thicker insulation for copper. With Rockford Fosgate, you get exactly what you pay for.

Includes Power Wire

This amplifier kit includes power wire by including necessary cable for both B(+) and GND(-) connections. Additionally, amplifier kits include remote turn-on power wire. All cables in this kit conform to the CEA-2015 AWG specification.

Dual Amp Installation

This amplifier kit is designed to install two amps in one system. This includes all necessary cables for proper connection; power, ground, turn-on and RCA signal. All cables in this kit conform to the CEA-2015 AWG specification.

Includes Speaker Wire

This amplifier kit includes speaker wire. These cables connect the amplifier to the speakers. All wires in this kit conform to the CEA-2015 AWG specification.

Includes RCA Cables

This amplifier kit includes RCA patch cables. These are the necessary cables used to transfer low-level signal from the source unit to the amplifier, typically located in the rear of the vehicle.

Includes Fused Dist.

This amplifier kit includes fused distribution. It utilizes a stand-alone fuse holder that can be installed in a convenient place under the hood.