Rockford Fosgate T1D210 Power 10″ T1 2-Ohm DVC Subwoofer

The T1D210 subwoofer features innovative technologies that allow it to perform like a larger woofer than the previous model. The T1 10″ has two 2-Ohm voice coils, 600 Watts RMS power handling, and an inbuilt trim ring in the grille. The Rockford Fosgate Power Series T1D210 Dual 2-Ohm subwoofer incorporates cutting-edge new Rockford Fosgate technologies. The T1D210 features patented VAST technology, which increases surface cone area by up to 25% over the previous model, giving it the performance of a much larger woofer. The new FlexFit basket not only looks the part, but it also gives you a lot of versatility in terms of installation. The T1D210 is here, clean, high-tech, and ready to set off vehicle alarms!

Bass Beats That Draw A Crowd

Power Series subs were designed by Rockford Fosgate for ultimate high-power, high-volume bass. A responsive paper cone is strengthened with the same Kevlar® fibres used in bulletproof vests, and a hard anodized aluminium dust cap covers and protects the entire cone of the T1D210, displaying the glossy Rockford Fosgate emblem. What’s the end result? From a nearly unbreakable cone, you get authentic warm bass.

Large Cone Area Equals Much More Bass

The enlarged rubber surround is attached to the cone using Rockford Fosgate’s patent-pending VAST technology, which increases usable cone area by 25%, allowing this sub to push more air for even more bass.

Extensive Journey

An extended pole piece and bumped backplate in the T1D210 give the sub a sturdy base for intense cone excursion, while a longer pole piece and bumped backplate allow it to hit deeper lows without “bottoming out.” The aluminium voice coils are kept cool by special ventilation in the frame, resulting in consistent bass performance throughout time.

Impedance Selection With Fuse Protection

Power Series subs are equipped with Rockford Fosgate’s innovative SWIFTTM terminals, which allow you to design exactly the system you want – high-power or multi-sub — without having to deal with intricate wiring. To choose between 1 and 4 ohms, simply rotate the impedance selection jumper. If you plan on adding another sub in the future, the T1D210 sub will make it easier to reconfigure your system.

The jumper is additionally fused to prevent inadvertent overloading of your sub. You may use these subs in either a sealed or ported enclosure, so you can get the bass you want for your system.

Available Wiring Diagrams For The T1D210

Wiring Diagram #1

Wiring Diagram #2

Wiring Diagram #3

Wiring Diagram #4

Wiring Diagram #5

Wiring Diagram #6

Wiring Diagram #7
\
Wiring Diagram #8

Wiring Diagram #9